WHEREAS Orientation and Mobility Specialists have observed that when visually impaired pedestrians approach streets at curb ramps they are at risk of walking unaware into the path of moving traffic, since there is no clearly defined distinction at curb ramps between the roadway and sidewalk; and
WHEREAS research has now been conducted which confirms that for persons who are visually impaired there is a high level of risk of inadvertent street entry associated with the presence of curb ramps, particularly those having slopes of 1:12 or less (Bentzen, B. & Barlow, J., 1995; Hauger, S., Rigby, J., Safewright, M. and McAuley, W., 1996); and
WHEREAS it has been demonstrated that detectable warnings complying with ADAAG 4.29.2 are highly detectable by persons with visual impairments, and can provide an effective stop signal for persons who are blind or visually impaired which can be used to determine the end of the sidewalk and the beginning of the vehicular way; and
WHEREAS research has now been conducted which addresses concerns about safety of detectable warnings, indicating that detectable warnings on slopes have minimal impact on the safety and ease of travel for persons having physical disabilities (Bentzen, B., Nolin, T., Easton, R., Desmaris P., and Mitchell, P., 1994; Hauger, et al, 1996); and
WHEREAS research has demonstrated that 24 inches of detectable warning material is sufficient to enable persons who are blind or visually impaired to stop on 90% of approaches (Peck, A. & Bentzen, B., 1987); and
WHEREAS it was the nearly unanimous recommendation of the workshop “Information at Intersections” sponsored by the U.S. Access Board and Project ACTION in January, 1995, that no additional research was needed on detectable warnings at curb ramps and that a detectable warning should forthwith be required on the full width of curb ramps beginning at the curb line and extending back 24”; and
WHEREAS numerous municipalities in the United States have installed detectable warnings on curb ramps and have reported no instances in which safety has been compromised by the presence of detectable warnings on curb ramps;
NOW THEREFORE BE IT RESOLVED, this 12th day of July, 1998, in the city of Atlanta, Georgia, that the Association for Education and Rehabilitation of the Blind and Visually Impaired (AER) urges the U.S. Access Board to provide specific opportunity for public comment on detectable warnings at curb ramps and hazardous vehicular ways when the notice of proposed rulemaking for the revised ADA Accessibility Guidelines is published.
BE IT FURTHER RESOLVED that AER continues to strongly advocate the provision of a 24” wide detectable warning surface at the bottom of curb ramps and at hazardous vehicular ways, particularly where those hazardous vehicular ways are blended curbs or raised crossings at intersections. (See AER Resolution 94-08).
BE IT FURTHER RESOLVED that AER urges Transport Canada to require a 24” wide detectable warning surface at the bottom of curb ramps and at hazardous vehicular ways, particularly where those hazardous vehicular ways are blended curbs or raised crossings at intersections.
Unanimously approved.
WHEREAS the Americans with Disabilities Act guarantees the right of access to information to persons with disabilities; and
WHEREAS many signalized intersections provide information to pedestrians with sight which is not provided to pedestrians with visual impairments; and
WHEREAS it has been demonstrated (Crandall, W., Bentzen, B.L., and Myers, L., 1998) that competent, independent, blind pedestrians at unfamiliar signalized intersections may initiate as many or more than 34% of crossings during the clearance or DON’T WALK intervals if those intersections are not equipped with accessible pedestrian signals; and
WHEREAS accessible pedestrian signals have been widely used for more than 10 years in countries including Australia, Japan, Sweden, and the United Kingdom and are considered by traffic engineers to be widely effective not only in providing information to blind pedestrians but also in decreasing general pedestrian delay and facilitating vehicular flow at signalized intersections; and
WHEREAS increasing numbers of quiet vehicles, including electric vehicles and those with quiet internal combustion engines, make acoustic information from vehicles inconsistent, resulting in the inability of pedestrians who are blind to reliably detect the onset of the WALK interval by listening for a surge of vehicles; and
WHEREAS inexpensive technologies exist to make Accessible Pedestrian Signals which are automatically responsive to ambient sound, being very quiet at night and in low traffic situations, while still loud enough to be heard above vehicular sound in high traffic situations; and
WHEREAS accessible vibrotactile and speech transmission signal systems exist which add no noise to the environment; and
WHEREAS the Transportation Equity Act for the 21st Century provides that “Transportation plans and projects. . .shall include the installation, where appropriate, and maintenance of audible traffic signals and audible signs at street crossings;”
NOW THEREFORE BE IT RESOLVED, this 12th day of July, 1998, in the city of Atlanta, Georgia, that the Association for Education and Rehabilitation of the Blind and Visually Impaired (AER) urges the U.S. Federal Highway Administration and Transport Canada to develop recommended practices for installation of pedestrian signals which make information which is regularly provided to other pedestrians, accessible to pedestrians who are visually impaired, including but not limited to: information specifying WALK and DON’T WALK intervals; information indicating the presence and location of push-buttons; and information unambiguously indicating the street to which the signal applies.
Unanimously approved.
WHEREAS traffic engineers are increasingly utilizing signal systems in which the only safe time to cross signalized intersections is provided in response to pedestrian use of a push button; and
WHEREAS persons who are visually impaired consistently identify location of the push button as a major problem they experience at pedestrian actuated intersections (American Council of the Blind survey, 1998; Evaluation of Audible Pedestrian Traffic Signals, San Diego Association of Governments, 1988; Uslan, M., 1988; and Tauchi, M., Sawai, H., Takato, J., Yoshiura, T., and Takaeuchi, K., 1998); and
WHEREAS persons who are visually impaired often have insufficient time when pedestrian push buttons are far from associated crosswalks, to actuate push buttons and then prepare to cross before the onset of the WALK interval (American Council of the Blind survey, 1998; San Diego Association of Governments, 1998; Uslan, M., 1988); and
WHEREAS unobtrusive technologies exist for providing information in accessible format, specifying the presence and location of push buttons;
NOW THEREFORE BE IT RESOLVED on this 12th day of July, 1998, in the city of Atlanta, Georgia, that the Association for Education and Rehabilitation of the Blind and Visually Impaired (AER) urges the U.S. Federal Highway Administration and Transport Canada to develop standards for push button location technology such as quiet audible locator tones, and to require the placement of newly installed pedestrian push buttons in close proximity to the top landing of the curb ramp serving that crossing, within accessible reach range for use from a wheelchair, and near enough to the curb line that persons with visual impairments can actuate the push button and then align and prepare for crossing before the onset of the WALK interval.
Unanimously approved.